Crossmember - Full Width - 3.8

Halves are also available if you are able to salvage the center section inside of the tunnel.

Our crossmember pieces are MUCH thicker than the stock or other aftermarket units at TRUE 19-gauge instead of a thin 20... They are also the correct dimensions, especially in the center support piece, and the HEIGHT - others are notoriously short. Finally, we DO NOT include the tabs on the outer ends - this is a weak, spot-welded connection from the factory that is difficult to secure.

Because our crossmember pieces are so thick, we simply trim them for an exact fit - and for that reason, the halves will work on either side. Then, we weld them directly to the 18-gauge inner sill.

Basically, on this panel - everything else out there is junk in our opinion...

Delivered in fresh, bare steel coated in a light oil for rust-prevention, simply wipe down with solvent before priming.